Bright Steel
EN3B; 080A15; 070M20; 1.0402
A mild steel used for general engineering purposes. Suitable for lightly stressed
components. This material has good machining properties and is suitable for welding.
Supplied as:
Round Bars: 3mm/0.125ӯ to 215.9mm/8.5ӯ
Square Bars: 6.35mm to 152.4mm
Flat Bars: 10mm x 3mm to 250mm x 20mm and 1/2” x 1/8” to 12” x 1”
EN24 Annealed; 817M40; 1.6565
Supplied in softened condition for machinability and can be hardened and tempered
to a wide range of strengths after machining.
Supplied as:
Round Black Bars: 45mmØ to 305mmØ
EN19; 709M40; 1.7225
A Chromium Molybdenum high tensile through hardening steel capable of surface
hardening by nitriding. Available in ”T” condition as well as annealed.
Supplied as:
Round Bright Bars: 16mmØ to 65mmØ
Round Black Bars: 40mmØ to 280mmØ
EN36B; 655M13; 1.5752
This is a high quality Nickel Chromium case-hardening steel which after hardening
develops an extremely tough core. The presence of nickel and chromium permits deep hardening.
Supplied as:
Round Black Bars: 20mmØ to 305mmØ
EN39B; 835M15; 1.6723
This is a case-hardening steel used where very high core strength is required.
Supplied as:
Round Black Bars: 76mmØ to 240mmØ
SAE 8620; 805A20; 1.6523
A low alloy case hardening steel to American AISI/SAE standards, which after
carburising and hardening produces a hard, wear resistant case with a tough core.
Supplied as:
Round Black Bars: 45mmØ to 200mmØ
Other grades and sizes available on request.