Aluminium
Precision Machined Cast Aluminium Plate
MIC6 Specifications
| TYPICAL PROPERTIES | |
|---|---|
| Tensile Strength: | Typical 24 ksi / 166 MPa |
| Yield Strength: | Typical 15 ksi / 105 MPa |
| Percent of Elongation: | 3% |
| Brinell: | 65 |
| Coefficient of Thermal Expansion (average) | |
| 68 to 212 °F (20 to 100 °C): | 13.1 x 10-6 in/in ·°F 23.6 x 10-6 m/m · K |
| 68 to 392 °F (20 to 200 °C): | 13.6 x 10-6 in/in ·°F 24.5 x 10-6 m/m · K |
| Thermal Conductivity: | 0.34 cal/cm · s · °C 142 W/m · K 82 Btu/ft · h · °F |
| Electrical Conductivity, IACS: | 36% |
| Modulus of Elasticity: | 10.3 x 106 psi / 71,000 MPa |
| MILL SIZES | |
|---|---|
| Non-standard thicknesses, widths and lengths may be available on inquiry. | |
| Standard Thicknesses: | 1⁄4" - 4" 6 - 100mm |
| Standard Widths: | 48.5" & 60.5" 1232 & 1537mm |
| Standard Lengths: | 96.5", 120.5" & 144.5" 2451, 3061 & 3670mm |
| TOLERANCES | |
|---|---|
| Flatness tolerances at the mill are measured using a laser system and/or granite flatness table. The tolerances apply to both standard mill origin plate and to cut blanks when proper cutting techniques and equipment are used. | |
| Surface Each side is machined to a maximum 20 microinch or 0.50 micron smoothness. |
|
| Edge Condition | |
| Width: | milled or saw cut |
| Length: | saw cut |
| Mill Plate | |
| Length tolerance: | +1⁄2" -0. / +13mm -0. |
| Width tolerance: | +1⁄4" -0. / +7mm -0. |
| Thickness tolerance | |
| The tolerance for any thickness is ±.005" /±.127mm. | |
| Flatness tolerance: Specified plate thickness maximum variation: |
|
| 3⁄4" and over: .005" / 19mm and over: .127mm | |
| 1⁄4" to 5⁄8": .015" / 6mm and over: .381mm | |
THE ULTIMATE INDUSTRY STANDARD FOR
Flatness • Dimensional stability • Tolerance control during machining
For further technical information or additional sizes on this product or any other product or service please contact us.